Skip to content
Heat Pump Fault Finder AU

Verified codeset result

The manufacturer documentation publishes fault code PB for the Monoblock controller display, mapped to the affected Haier models listed below.

Fault code PB

Haier Monoblock controller display: PB

Monoblock controller display

Haier logo (for identification)

Last verified from the captured official source review.

PB meaning for this display codeset

This page isolates Haier fault code PB for the Monoblock controller display. It does not combine the Haier PB meaning with another controller or codeset.

Before applying the Haier PB meaning, confirm the affected model uses the Monoblock controller display. In that controller namespace, PB means documented as compressor out of step.

The Haier Monoblock Heat Pump Water Heater Operation and Installation Manual V1125 source anchor on page 47 supports this Haier PB record for the Monoblock controller display.

The permanent source key haier-monoblock-display PB keeps the haier-monoblock-display PB controller/code pairing distinct in publication.

What the documentation says

Documented as Compressor out of step.

This is a paraphrase of the manufacturer’s documentation. A licensed technician confirms the actual cause.

Severity

Amber — service attention

Amber means the fault needs attention; contact the manufacturer or a licensed technician if it persists.

Source-grounded diagnosis context

Documented causes

Repair, replacement and warranty context

Start with diagnosis, then compare repair and replacement

An amber classification usually calls for a diagnosis and repair quote, not automatic replacement. Compare parts availability, repair cost and system age only after the fault has been confirmed by an appropriately licensed professional.

This brand has a verified current Australian support route, so check warranty coverage with the manufacturer before authorising paid repair or replacement work.

Affected models

Every model mapped to this codeset is listed with the evidence match state used by this site.

Related codes from this codeset

These codes appear in the same documented controller or display codeset.

  • P6

    Documented as Over voltage protection.

  • P7

    Documented as The communication between the main control chip and the driver chip is abnormal.

  • P8

    Documented as The current detection on the frequency conversion side is abnormal.

  • PD

    Documented as Instantaneous software overflow on the rectifier Side.

  • PF

    Documented as Transient hardware overcurrent on the rectifier side.

Choose the right next step

Warranty or local repair?

Answer both questions. If the unit may be covered, we will direct you to the manufacturer first. Your answers stay in this page unless you submit a repair request.

Choose both answers to see the recommended route.

Official source

Where this result comes from

Haier. Haier Monoblock Heat Pump Water Heater Operation and Installation Manual V1125, PDF page 47. Retrieved .

Report a problem with this page