Skip to content
Heat Pump Fault Finder AU

Verified codeset result

The manufacturer documentation publishes fault code P2 for the All-In-One Pro controller display, mapped to the affected Emerald Energy models listed below.

Fault code P2

Emerald Energy All-In-One Pro controller display: P2

All-In-One Pro controller display

Emerald Energy logo (for identification)

Last verified from the captured official source review.

P2 meaning for this display codeset

This page isolates Emerald Energy fault code P2 for the All-In-One Pro controller display. It does not combine the Emerald Energy P2 meaning with another controller or codeset.

Before applying the Emerald Energy P2 meaning, confirm the affected model uses the All-In-One Pro controller display. In that controller namespace, P2 means documented as compressor fails to be driven/software control.

The Emerald Heat Pump All-In-One Pro Instructions source anchor on page 27 supports this Emerald Energy P2 record for the All-In-One Pro controller display.

The permanent source key emerald-all-in-one-pro-display P2 keeps the emerald-all-in-one-pro-display P2 controller/code pairing distinct in publication.

What the documentation says

Documented as Compressor fails to be driven/Software control.

This is a paraphrase of the manufacturer’s documentation. A licensed technician confirms the actual cause.

Severity

Amber — service attention

Amber means the fault needs attention; contact the manufacturer or a licensed technician if it persists.

Repair, replacement and warranty context

Start with diagnosis, then compare repair and replacement

An amber classification usually calls for a diagnosis and repair quote, not automatic replacement. Compare parts availability, repair cost and system age only after the fault has been confirmed by an appropriately licensed professional.

This brand has a verified current Australian support route, so check warranty coverage with the manufacturer before authorising paid repair or replacement work.

Affected models

Every model mapped to this codeset is listed with the evidence match state used by this site.

Related codes from this codeset

These codes appear in the same documented controller or display codeset.

  • P17

    Documented as Compressor over current alarm.

  • P18

    Documented as Compressor weak magnetic alarm.

  • P19

    Documented as PIM overheat alarm.

  • P20

    Documented as PFC overheat alarm.

  • P21

    Documented as AC input over current alarm.

  • P22

    Documented as EEPROM alarm.

Choose the right next step

Warranty or local repair?

Answer both questions. If the unit may be covered, we will direct you to the manufacturer first. Your answers stay in this page unless you submit a repair request.

Choose both answers to see the recommended route.

Official source

Where this result comes from

Emerald Energy. Emerald Heat Pump All-In-One Pro Instructions, PDF page 27. Retrieved .

Report a problem with this page