Skip to content
Heat Pump Fault Finder AU

Verified codeset result

The manufacturer documentation publishes fault code P20 for the All-In-One Pro controller display, mapped to the affected Emerald Energy models listed below.

Fault code P20

Emerald Energy All-In-One Pro controller display: P20

All-In-One Pro controller display

Emerald Energy logo (for identification)

Last verified from the captured official source review.

P20 meaning for this display codeset

This page isolates Emerald Energy fault code P20 for the All-In-One Pro controller display. It does not combine the Emerald Energy P20 meaning with another controller or codeset.

Before applying the Emerald Energy P20 meaning, confirm the affected model uses the All-In-One Pro controller display. In that controller namespace, P20 means documented as pfc overheat alarm.

The Emerald Heat Pump All-In-One Pro Instructions source anchor on page 27 supports this Emerald Energy P20 record for the All-In-One Pro controller display.

The permanent source key emerald-all-in-one-pro-display P20 keeps the emerald-all-in-one-pro-display P20 controller/code pairing distinct in publication.

What the documentation says

Documented as PFC overheat alarm.

This is a paraphrase of the manufacturer’s documentation. A licensed technician confirms the actual cause.

Severity

Red — urgent safety concern

Red means the documented fault involves safety-critical, leak, electrical, refrigerant, lockout or overheat language.

Repair, replacement and warranty context

Prioritise safety before the repair-or-replace decision

A red classification warrants urgent assessment by an appropriately licensed professional. The code alone cannot establish whether a component repair or full system replacement is proportionate.

This brand has a verified current Australian support route, so check warranty coverage with the manufacturer before authorising paid repair or replacement work.

Affected models

Every model mapped to this codeset is listed with the evidence match state used by this site.

Related codes from this codeset

These codes appear in the same documented controller or display codeset.

  • P18

    Documented as Compressor weak magnetic alarm.

  • P19

    Documented as PIM overheat alarm.

  • P2

    Documented as Compressor fails to be driven/Software control.

  • P21

    Documented as AC input over current alarm.

  • P22

    Documented as EEPROM alarm.

  • P25

    Documented as Temperature sensor failure to lead frequency limit.

Choose the right next step

Warranty or local repair?

Answer both questions. If the unit may be covered, we will direct you to the manufacturer first. Your answers stay in this page unless you submit a repair request.

Choose both answers to see the recommended route.

Official source

Where this result comes from

Emerald Energy. Emerald Heat Pump All-In-One Pro Instructions, PDF page 27. Retrieved .

Report a problem with this page