Skip to content
Heat Pump Fault Finder AU

Verified codeset result

The manufacturer documentation publishes fault code U0 for the V2 external controller and heat pump PCB error-code display, mapped to the affected Reclaim Energy models listed below.

Fault code U0

Reclaim Energy V2 external controller and heat pump PCB error-code display: U0

V2 external controller and heat pump PCB error-code display

Reclaim Energy logo (for identification)

Last verified from the captured official source review.

U0 meaning for this pcb codeset

This page isolates Reclaim Energy fault code U0 for the V2 external controller and heat pump PCB error-code display. It does not combine the Reclaim Energy U0 meaning with another controller or codeset.

Before applying the Reclaim Energy U0 meaning, confirm the affected model uses the V2 external controller and heat pump PCB error-code display. In that controller namespace, U0 means documented as a stop triggered by detection of gas leakage.

The Reclaim Energy V2 Installation Manual, Issue 15 (June 2026) source anchor on page 23 supports this Reclaim Energy U0 record for the V2 external controller and heat pump PCB error-code display.

The permanent source key reclaim-energy-v2-controller-pcb U0 keeps the reclaim-energy-v2-controller-pcb U0 controller/code pairing distinct in publication.

What the documentation says

Documented as a stop triggered by detection of gas leakage.

This is a paraphrase of the manufacturer’s documentation. A licensed technician confirms the actual cause.

Severity

Red — urgent safety concern

Red means the documented fault involves safety-critical, leak, electrical, refrigerant, lockout or overheat language.

Source-grounded diagnosis context

Documented causes

Qualified service work

What a technician will check

These are paraphrased technician-facing checks from the manual, not homeowner instructions.

Repair, replacement and warranty context

Prioritise safety before the repair-or-replace decision

A red classification warrants urgent assessment by an appropriately licensed professional. The code alone cannot establish whether a component repair or full system replacement is proportionate.

This brand has a verified current Australian support route, so check warranty coverage with the manufacturer before authorising paid repair or replacement work.

Affected models

Every model mapped to this codeset is listed with the evidence match state used by this site.

Related codes from this codeset

These codes appear in the same documented controller or display codeset.

  • L4

    Documented as a module temperature error at 90°C or higher.

  • L5

    Documented as detected output overcurrent.

  • P4

    Documented as a module sensor error.

  • U2

    Documented as a power voltage error.

Choose the right next step

Warranty or local repair?

Answer both questions. If the unit may be covered, we will direct you to the manufacturer first. Your answers stay in this page unless you submit a repair request.

Choose both answers to see the recommended route.

Official source

Where this result comes from

Reclaim Energy. Reclaim Energy V2 Installation Manual, Issue 15 (June 2026), PDF page 23. Retrieved .

Report a problem with this page